Mounting A Wall Hung Sink On A Steel Stud Wall

Use a level to make sure the mounting bolts are level.

Mounting a wall hung sink on a steel stud wall.

Place the mounting plate in the installation location and mark the wall through each of the mounting holes. Install the threaded inserts to hold the bolts in place. If there is no mounting plate use the holes in the back of the sink basin as your template. Some sinks will require the use of a mounting bracket.

Measure the sink installation height again and draw a mark using the level. The sink should be anchored to two wall studs. When your walls lack the studs to accommodate a pedestal sink you must use toggle bolts and. Remove the 2 x 10 from the wall and drill 1 2 inch holes through the layout marks.

More often than not a pedestal sink s mounting holes will not line up with existing wall studs. Manufacturer number size name dimensions a c f rim height. Slip the sink over the mounting bolts and finger tighten the mounting nuts over the washers. Remove the plasterboard from the studs and insert noggins so that the supporting bolts can be screwed directly into them at the 2 locations previously marked.

Wall mount concealed arm withconcealedarms leveling securingscrewsandsteel plate for attaching to studs. 1 position the sink or its mounting plate if it has one on the wall and mark the wall through the holes in the plate or sink. Insert the mounting bolts. Measuring off the top of the basin note the position of the 2 x supporting bolt holes on the back and transfer these marks onto the wall centring the basin in its intended location.

Smear pipe dope onto the threads of the supply line compression fittings and tighten them onto the faucet supply lines. Fasten the 2 x 10 brace to the wall studs by using 2 1 2 inch screws. Lift the sink slightly while tightening the nuts with a wrench. Follow the manufacturer s instructions to mount the wall mount bathroom sink.

To do this bridge the studs with a stud or track cut so that it s equal to the length of the wall. Standard adjustable sleeve is 4. Toenail the blocking to the studs with 3 1 2 inch galvanized common nails or screw it with 3 inch decking screws. Hold the mounting bracket against the wall at the proper height and drill a pilot hole into the wall studs.

Based on a dim shown. First you want to strengthen the wall behind the sink. Mount the sink to the wall.